4 years ago#1
Guest
Guest

hi,i want to cast a oramament lith latex /fiberglass what release
agent do i put on the latex so it will not stick,thanks.

Answer
4 years ago#2
jade
Platinum Member
Blogs: 0
Forum: 405
Votes: 5

I think you may find an answer on the related posts list at the bottom of this page. You can check this thread too: http://www.mysculpturesgallery.com/hello.-i-want-to- make-a-casing-for-a-latex-mold-using-epoxy-...- 45694.html

Reply
3 years ago#3
mick pearson
Guest

latex rubber or silicons do not need release agents on them with resin as it wont stick to rubber hope i helped out a little

Reply
By entering this site you declare you read and agreed to its Terms, Rules & Privacy and you understand that your use of the site's content is made at your own risk and responsibility.
Copyright © 2006 - 2015 My Sculptures Gallery