My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

course

...s in Berlin. Oh yeah, and has done a whole lot of shows. The reason I wanted to find out about him of course is that I am completely taken with his work, which I recently ran into on Moon River. H...
...h at times managed to be unaware of the wonder in making until the actual opening ceremony. I have now of course read about it extensively and on of my favorite posts about it was on Hello Beautiful, ...
...ng for bananas, If you are just getting into this field, I strongly advise you take a beginners welding course, buy a cheap mig welder and gas torch (and safety gear). You will find 100 uses for the...
...ily scratched (once it's cured), overall ease of use, easy to brush and level out yet drying fast. And of course - UV resistance (to yellowing, peeling, etc.) and overall longevity. If it's availabl...
...g. I eventually got so frustrated with it that I gave up and bolted them together. I'm doing an evening course at the moment where I'm learning on a similar machine, but I haven't tried to weld anyt...
... motor oil (new or used) carbolated vaseline yellow axle grease hemp seed oil Bag Balm And, of course, the obvious, seal oil Experiment on a scrap of stone. Good luck,...
I would like to find a good course (Intermediate) on sculpting in London (evenings/w/ends). Can anyone help please?
...sed portions if I just barely nudged it the wrong way, it chipped or flaked with the grain of the wood of course, destroying my raised areas. Question is - was I just doing it wrong ? Or is this the w...
Hello, I'm taking a college course in Sculpture and I need to make a mold for a Tsungite block or Japanese wood block. The only thing is I don't know how...My teacher said that I would have to figur
...mpany restores and replicates plaster detailing, moldings, etc. on old buildings. He mentioned during the course of the segment that they use 'stearic...?(can't remember)' as a mold release. He said i...
...e craftsman green? Whether to sign your name on the left or the right before it's cast by the foundry? Of course the artist can always review the work in progress, that a given. It's the artist vision...
...t tape, and if space is tight, disassembled when not needed. You can make a spray booth this way, too. Of course - if you're using flammable stuff, then that's a whole different ballgame. Then the fan...
...ten the surface of the plastilene- you need merely wait a few hours for the volatiles to flash off. For a courser grit, use old sheets. Also- both wax and hard plastilenes can be kept maleable by usin...
...d would appreciate recommendations for a glue which will present the least visible glue line (assuming of course, my boards are well planed), has a slow set up time, and, will last. Much Obliged, Etha...
Of course a bronze sculpture by a well known artist for $30,000 sounds like a great deal. However a bronze sculpture by a lesser known artist (at least at this time) for less than $3,000 sounds like a
FIRST INTERCOURSE! WOULD YOU LIKE TO SEE? www.geocities.com/Eureka/Mine/2753 ptvonjxvgueqhmevmvjqlhnebzpdnqtukpmfyzfmysctltbyutw '
Page: 1

Copyright © 2006 - Jan 2009 My Sculptures Gallery